Toyota Sienna Quiz
Air conditioning

Rear Air Conditioning Relay Circuit

In this manual: Air conditioning
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

DESCRIPTION

The RR A/C relay is switched on by signals from the A/C amplifier. It supplies power to the rear blower motor.

WIRING DIAGRAM

Rear Air Conditioning Relay Circuit

INSPECTION PROCEDURE

1 INSPECT RELAY (RR A/C)

INSPECT RELAY (RR A/C)

(a) Remove the RR A/C relay from the No. 3 relay block.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance

2 CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)

CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)

(a) Disconnect the connector from the A/C amplifier.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.