Front Power Seat does not Operate with Front Power Seat Switch
In this manual: Vehicle Interior
~1min read
DESCRIPTION
When a signal is input into the position control ECU and switch assembly, the ECU manages the signals received from the power seat switches, and operates each motors. If the position control ECU and switch assembly receives more than 2 motors operation signals, the motor is stopped. Manual operation is restarted after the position control ECU and switch assembly receives 1 signal only.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK FRONT POWER SEAT OPERATION
(a) Check that each function of the power seat operates normally by using the power seat switches (See page ).
Result
Result
Proceed to
All power seat functions does not operate
A
One or more power seat functions does not operate
B
B
Go to OTHER FLOW CHART (One or more Power Seat Motors do not Operate)
A
CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH ASSEMBLY - BATTERY AND BODY GROUND)
(a) Disconnect the Z9 and Z10 position control ECU and switch assembly connectors.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
Z9-7 (+B1) - Body ground
Always
11 to 14 V
Z10-12 (SYSB) - Body ground
Always
11 to 14 V
(c) Measure the resistance according to the value(s) in the table below.