Engine, Hybrid System
Inspection
In this manual: Engine, Hybrid System
~1min read
INSPECTIONPROCEDURE1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
(a) Partially immerse the sensor in water and warm up the water. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the engine coolant temperature sensor. NOTICE: When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry. HINT: If the result is as specified, do not replace the engine coolant temperature sensor. |
Was this page helpful?