Vehicle Interior
No Communication in Immobiliser System (B2796)
DESCRIPTION
This DTC is stored when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU assembly.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
B2796 |
No Communication in Immobiliser System |
The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*). |
- Key
- Transponder key coil
- Transponder key ECU assembly
|
- Insert the key into the ignition key cylinder.
|
- *: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
Engine cannot be started |
- |
Related Data List and Active Test
DTC No. | Data List and Active Test |
B2796 |
Response |
WIRING DIAGRAM
NOTICE:
- If the transponder key ECU assembly or key is replaced, refer to Registration.
Click here 
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CLEAR DTC
(a) Clear the DTCs.
Click here 
| NEXT |
 |
|
CHECK FOR DTC
(a) Insert and remove each registered key one at a time, and check for DTCs each time.
Click here 
HINT:
- Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
- If DTC B2796 is stored, check for DTCs with the next key after clearing the DTCs.
OK:
DTC B2796 is not output.
Result | Proceed to |
B2796 is not output |
A |
DTC B2796 is output for all of the keys |
B |
DTC B2796 is output for any of the keys |
C |
| A |
 |
USE SIMULATION METHOD TO CHECK |
| C |
 |
GO TO STEP 8 |
| B |
 |
|
REPLACE TRANSPONDER KEY ECU ASSEMBLY
(a) Replace the transponder key ECU assembly with a new one.
Click here 
| NEXT |
 |
|
REGISTER KEY
(a) Register the key.
Click here 
| NEXT |
 |
|
REGISTER ECU COMMUNICATION ID
(a) Register the ECU communication ID.
Click here 
| NEXT |
 |
|
CLEAR DTC
(a) Clear the DTCs.
Click here 
| NEXT |
 |
|
CHECK FOR DTC
(a) Check for DTCs.
Click here 
HINT:
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
OK:
DTC B2796 is not output.
Result | Proceed to |
B2796 is not output |
A |
B2796 is output |
B |
| A |
 |
END (TRANSPONDER KEY ECU ASSEMBLY WAS DEFECTIVE) |
| B |
 |
REPLACE KEY THAT DTC IS OUTPUT |
REPLACE KEY
(a) Replace the key for which the DTC was stored.
Click here 
| NEXT |
 |
|
CLEAR DTC
(a) Clear the DTCs.
Click here 
| NEXT |
 |
|
CHECK FOR DTC
(a) Check for DTCs.
Click here 
HINT:
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
OK:
DTC B2796 is not output.
Result | Proceed to |
B2796 is not output |
A |
B2796 is output |
B |
| A |
 |
END (KEY WAS DEFECTIVE) |
| B |
 |
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
|
Was this page helpful?