DESCRIPTION
The transponder key ECU assembly blinks the security indicator light when the engine immobiliser is set.
WIRING DIAGRAM
NOTICE:
If the transponder key ECU assembly is replaced, refer to Registration.
Click here 
PROCEDURE
PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Immobiliser / Active Test.
(e) Perform the Active Test according to the display on the Techstream. Immobiliser
Tester Display | Test Part | Control Range | Diagnostic Note |
Security Indicator |
Security indicator light |
ON/OFF |
- |
OK:
Security indicator light can be turned on and off using the Techstream.
| OK |
 |
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
| NG |
 |
|
CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - COMBINATION METER ASSEMBLY (SECURITY INDICATOR LIGHT))
(a) Disconnect the J26 transponder key ECU assembly connector.
(b) Disconnect the J28 combination meter assembly (security indicator light) connector.
(c) Disconnect the J165 main body ECU (multiplex network body ECU) connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J28-36 (LP) - J26-8 (IND) |
Always |
Below 1 Ω |
J28-36 (LP) - Body ground |
Always |
10 kΩ or higher |
J26-8 (IND) - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK TRANSPONDER KEY ECU ASSEMBLY (TERMINAL IND)
(a) Connect the J26 transponder key ECU assembly connector.
(b) Measure the voltage and check for pulses according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
J28-36 (LP) - Body ground |
Ignition switch off |
Pulse generation |
Ignition switch ON |
Below 1 V |
|
 |
*a |
Front view of wire harness connector
(to Combination Meter Assembly (Security Indicator Light)) |
|
|
| OK |
 |
REPLACE COMBINATION METER ASSEMBLY (SECURITY INDICATOR LIGHT) |
| NG |
 |
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
|