Vehicle Interior
Theft Deterrent System Presence Detection (B279C)
DESCRIPTION
This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
B279C |
Theft Deterrent System Presence Detection |
An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). |
ECM |
|
- *: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
Engine cannot be started |
- |
Related Data List and Active Test
DTC No. | Data List and Active Test |
B279C |
- |
NOTICE:
- If the ECM is replaced, refer to Registration.
Click here 
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CLEAR DTC
(a) Clear the DTCs.
Click here 
| NEXT |
 |
|
CHECK FOR DTC
(a) Start the engine.
(b) Check for DTCs.
Click here 
HINT:
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
OK:
DTC B279C is not output.
| OK |
 |
USE SIMULATION METHOD TO CHECK |
| NG |
 |
|
REPLACE ECM
(a) Replace the current ECM with the proper ECM.
- for 1UR-FE:
Click here 
- for 3UR-FE:
Click here 
- for 3UR-FBE:
Click here 
| NEXT |
 |
END |
|
Was this page helpful?