DTC B2793 is stored when a malfunction is found in the key during key ID code registration or a key ID code is not registered normally. Replace the key if key ID code registration cannot be performed normally and this DTC is output.
DTC B2794 is stored when a key with an incomplete key ID code is inserted into the ignition key cylinder.
DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.
DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
B2793
Transponder Chip Malfunction
A transponder chip malfunction (1 trip detection logic*).
Transponder key coil
Transponder key ECU assembly
Insert the key into the ignition key cylinder.
B2794
Unmatched Encryption Code
A key with an incomplete key ID code is inserted into the ignition key cylinder (1 trip detection logic*).
Transponder key coil
Transponder key ECU assembly
Insert the key into the ignition key cylinder.
B2797
Communication Malfunction No. 1
A key with a BCC malfunction is inserted into the ignition key cylinder (1 trip detection logic*).
Transponder key coil
Transponder key ECU assembly
Insert the key into the ignition key cylinder.
B2798
Communication Malfunction No. 2
Key ID code identification cannot be completed within the specified time (1 trip detection logic*).
Transponder key coil
Transponder key ECU assembly
Insert the key into the ignition key cylinder.
*: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-
Related Data List and Active Test
DTC No.
Data List and Active Test
B2793
Abnormal Status
B2794
Different Encrypt Code
B2797
Bcc Malfunction
B2798
Frame Error
NOTICE:
If the transponder key ECU assembly is replaced, refer to Registration
Click here
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CLEAR DTC
(a) Clear the DTCs.
Click here
NEXT
CHECK FOR DTC
(a) Insert and remove each registered key one at a time, and check for DTCs each time.
Click here
HINT:
Before checking for DTCs, perform "DTC Output Confirmation Operation" procedure.
If DTC B2793, B2794, B2797 or B2798 are stored, clear the DTCs before checking the next key.
OK:
DTC B2793, B2974, B2797 or B2798 is not output.
Result
Proceed to
DTCs are not output
A
DTCs are output for all of the keys
B
DTCs are output for any of the keys
C
A
USE SIMULATION METHOD TO CHECK
C
REPLACE KEY THAT DTC IS OUTPUT
B
CHECK CONNECTION OF CONNECTOR
(a) Check that the connectors are properly connected to the transponder key coil.