Vehicle Interior
Push Switch / Key Unlock Warning Switch Malfunction (B2780)
DESCRIPTION
This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
B2780
Push Switch / Key Unlock Warning Switch Malfunction
The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*).
Harness or connector
Unlock warning switch assembly
Transponder key ECU assembly
Insert the key into the ignition key cylinder.
*: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-
Related Data List and Active Test
DTC No.
Data List and Active Test
B2780
Key SW
WIRING DIAGRAM
NOTICE:
If the transponder key ECU assembly is replaced, refer to Registration. Click here
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CLEAR DTC
(a) Clear the DTCs.
Click here
NEXT
CHECK FOR DTC
(a) Check for DTCs.
Click here
HINT:
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
OK:
DTC B2780 is not output.
Result
Proceed to
B2780 is not output
A
B2780 is output
B
A
USE SIMULATION METHOD TO CHECK
B
INSPECT UNLOCK WARNING SWITCH ASSEMBLY
(a) Remove the unlock warning switch assembly.
Click here
(b) Inspect the unlock warning switch assembly.
Click here
NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK
CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - TRANSPONDER KEY ECU ASSEMBLY AND BODY GROUND)
(a) Disconnect the J18 unlock warning switch assembly connector.
(b) Disconnect the J26 transponder key ECU assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
J18-1 - J26-3 (KSW)
Always
Below 1 Ω
J18-2 - Body ground
Always
Below 1 Ω
J18-1 - Body ground
Always
10 kΩ or higher
J26-3 (KSW) - Body ground
Always
10 kΩ or higher
OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Was this page helpful? 👍 Yes 👎 No