Adjustment

1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Remove the transmission control shaft lever.

HINT:

See the steps from "Remove Cool Air Intake Duct Seal" through "Remove Park/Neutral Position Switch Assembly" (See page ).

(b) Loosen the 2 bolts of the park/neutral position switch.

(c) Align the protrusions of the park/neutral position switch. Text in Illustration *1 Protrusion

(d) Hold the park/neutral position switch in position and tighten the 2 bolts. Torque: 5,4 N·m {55 kgf·cm, 48 in·lbf} NOTICE: After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

(e) Install the transmission control shaft lever.

HINT:

See the steps from "Install Park/Neutral Position Switch Assembly" through "Install Cool Air Intake Duct Seal" (See page ).

(f) After the adjustment, perform the switch operation check (See page ).