Toyota Venza Quiz
Door / Hatch

Customize Parameters

In this manual: Door / Hatch
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
CUSTOMIZE PARAMETERS

HINT:

The following items can be customized.

NOTICE:

  • After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
  • Be sure to record the current settings before customization.
  • When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).

1. CUSTOMIZE

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Customize Setting.

(e) Select the setting by referring to the table below.

Power Back Door System

Tester Display

Default

Content

Setting

Wireless Power Back Door Open

Lock:0.8s/Unlock:0.8s*2

Function that operates the power back door by pushing the transmitter switch.

Lock:OFF/Unlock:OFF

Lock:OFF/Unlock:ON

Lock:OFF/Unlock:Twice

Lock:OFF/Unlock:0.8s

Lock:Twice/Unlock:Twice

Lock:0.8s/Unlock:0.8s

PBD SW Operation

0.8 s

Function that turns the power back door closer switch on when a switch is pushed once or held down for 0.8 sec. .

0.8 s or 0.0 s

PBD Buzzer*1

OFF

This function makes the power back door buzzer sound when the power back door is operating.

OFF or ON
  • *1:The warning buzzer that sounds when the power back door is operating cannot be customized. (Even if this function is set to "off", the buzzer will still sound.)
  • *2: Default setting differs depending on the country

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.