Toyota Venza Quiz
Heating / Air Conditioning

Installation

In this manual: Heating / Air Conditioning
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
INSTALLATION PROCEDURE

1. INSTALL NO. 1 COOLER THERMISTOR

(a) Install the No. 1 cooler thermistor as shown in the illustration.

Part

Length

A

34.3 mm

1.35 in.

B

20.9 mm

0.822 in.

C

50.0 mm

1.96 in.
Text in Illustration

*1

From Tank

*2

Fixed Part

*3

Sensor Part

NOTICE:

  • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
  • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
  • After inserting the thermistor, do not apply excessive force to the wire.
  • Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY


3. INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY


4. INSTALL COOLER EXPANSION VALVE


5. INSTALL AIR CONDITIONING HARNESS ASSEMBLY


6. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY


7. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY


8. INSTALL NO. 2 FINISH PANEL MOUNTING BRACKET


9. INSTALL NO. 1 FINISH PANEL MOUNTING BRACKET


10. INSTALL AIR CONDITIONING UNIT ASSEMBLY

(See page )

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.