Installation

1. INSTALL SHIFT LEVER ASSEMBLY

NOTICE:

Check that the park/neutral position switch and the shift lever are in neutral.

(a) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward. Text in Illustration *1 Slide *2 Pull *3 Slider *4 Lock Piece

(b) Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the stopper. Text in Illustration *1 Lock Nut *2 Push in *3 Stopper

(c) Connect the outer part of the transmission control cable to the shift lever retainer. Text in Illustration *1 Shift Lever Retainer *2 Stopper *3 Lock Nut NOTICE: The lock nut is fully seated against the shift lever retainer.

(d) Install the transmission control cable end to the shift lever assembly. Text in Illustration *1 Lock Piece NOTICE: Check that the lock piece is pulled up. Install the cable end all the way to the base of the pin.

(e) Install the shift lever assembly with the 4 nuts. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf}

(f) Connect the 2 connectors.

(g) Push the lock piece into the adjuster case. Text in Illustration *1 Push *2 Lock Piece NOTICE: Securely push in the lock piece until the slider lock is engaged.

2. INSTALL CONSOLE BOX SUB-ASSEMBLY

3. INSTALL POSITION INDICATOR HOUSING ASSEMBLY

4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

5. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

8. INSTALL FRONT DOOR SCUFF PLATE RH

9. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

11. INSTALL FRONT DOOR SCUFF PLATE LH

12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

13. INSTALL CONSOLE BOX ASSEMBLY

14. INSTALL NO. 2 CONSOLE BOX CARPET

15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

18. INSPECT SHIFT LEVER POSITION

19. ADJUST SHIFT LEVER POSITION