Removing and installing window regulator motor -V14-/-V15-

Note Removal and installation are only described for the left window regulator motor. Removal and installation of the right window regulator motor are similar. The door control unit -J386/J387--4- is separated from window regulator motor -V14/V15--1-. The door control unit -J386/J387- is clipped into door. Removing

Torque wrench -V.A.G 1783-

• Remove front door trim → General body repairs, interior; Rep. gr.70.
• Secure door window against sliding down with adhesive tape.
• Switch off ignition and all electrical consumers. Remove ignition key.
• Disconnect connector -3-.
• Remove bolts -2- (Qty. 3).
• Remove window regulator motor -1- from mounting brackets of cable drum.

WARNING If a new window regulator motor (door control unit) is installed, the additional functions and the excess force limitation feature have to be coded!

• Position window regulator motor -1- on mounting brackets of cable drum. Move door window up and down slightly so that the splines between window regulator motor and cable drum engage more easily.
• Connect connector -3-.
• A new window regulator motor must be coded using → Vehicle diagnostic tester.
• The work procedure and notes on the automatic window raising and lowering system as well as on the excess-force limitation feature can be found in → Booklet.

Further installation is performed in the reverse order of removal.

Specified torques