Brake system

Front brake caliper

9steps
~54min
2/5difficulty
01020304050107N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Remove and install brake caliper piston

Required special tools, testers and equipment, and auxiliary items

  • Release Wedge -3409-
VW UP. Bremsanlagen

  • Piston reset tool -T10145-

Removing:

- Press the piston out of the brake caliper using compressed air.

VW UP. Bremsanlagen

Place a wooden plate in the bore so the piston is not damaged.

VW UP. Bremsanlagen

- Remove the sealing ring using installation wedge 3409.

During removal, take care not to damage the surface of the cylinder.

Installing:

- Clean the surfaces of the piston and sealing ring only with denatured alcohol, then dry them.

- Before installation, apply a thin coat of assembly paste G 052 150 A2 to the piston and sealing ring.

- Insert the sealing ring into the brake caliper.

VW UP. Bremsanlagen

- Place the dust cap with the outer sealing lip onto the piston.

VW UP. Bremsanlagen

- Insert the inner sealing lip into the groove of the cylinder using installation wedge 3409.

Hold the piston in front of the brake caliper while doing so.

VW UP. Bremsanlagen

- Press the piston into the brake caliper using the piston reset tool.

The outer sealing lip of the dust cap snaps into the groove on the piston.

VW UP. Bremsanlagen

Assembly overview - front brake caliper

  • For repairs, install a complete repair kit.
  • Use only denatured alcohol to clean the brake.
  • Apply a thin coat of assembly paste G 052 150 A2 to the brake cylinder, piston and sealing ring.

Assembly overview - brake caliper FS III:

VW UP. Bremsanlagen

  1. Dust cap
    • Push onto bleeder valve.
  2. Bleeder valve, 10 N·m
    • Before screwing in, lightly grease the thread with assembly paste G 052 150 A2.
  3. Bearing bush
    • Insert into brake caliper.
  4. Guide pin, 30 N·m
  5. Cover caps
    • Insert into bearing bushing.
  6. Brake caliper
  7. Sealing ring
    • Remove and install
  8. Piston
    • Before installation, apply a thin coat of assembly paste G 052 150 A2 to the piston.
    • Remove and install
  9. Sealing ring
    • Remove and install