Electrical System General Information

Replacing lambda sensor

~2min read


Note

  • The lambda sensor wires must not be repaired, as this can cause malfunctions.
  • If required, fit the universal sensor with the supplied attachment parts, cable ties or marking tapes, using the defective sensor as a guide.
  • If necessary, identify the lambda sensor by its protective sleeve,

Replacing LSF lambda sensor (4-pin)


Note

  • If required, fit the universal sensor with the supplied attachment parts, cable ties or marking tapes, using the defective sensor as a guide.
  • The lambda sensor wires must not be repaired, as this can cause malfunctions.

- Remove the defective lambda sensor.

- Place the two lambda sensors side by side so that the sensor housings are at the same height.

VW UP. Elektrische Anlage Allgemeine Informationen

- Tie back the excess length of the universal sensor (approx. 50 - 250 mm) to match the length of the defective sensor and secure with cable ties, -1-

- Check that the connector housing of the lambda sensor is compatible with the vehicle wiring side.

- If necessary, replace the vehicle wiring connector with the supplied lambda sensor connector housing,


Note

  • The connector housing only needs to be replaced on older vehicles. On newer vehicles, the connector housing coding matches.
  • Observe the pin assignment. For easier identification, the individual pins in the new connector housing are marked with colour coding.
  • Additional information can be found in the leaflet supplied with the new lambda sensor.

- Install the new lambda sensor in the vehicle.

VW UP. Elektrische Anlage Allgemeine Informationen

Replacing LSU lambda sensor (6-pin)


Note

  • If required, fit the universal sensor with the supplied attachment parts, cable ties or marking tapes, using the defective sensor as a guide.
  • The wires must not be crimped or cut, as this will impair the function of the lambda sensor.

- Remove the old lambda sensor.

- Place the two lambda sensors side by side so that the sensor housings are at the same height.

VW UP. Elektrische Anlage Allgemeine Informationen

- Tie back the excess length of the universal sensor (approx. 50 - 250 mm) to match the length of the defective sensor and secure with cable ties -1-.

- Install the new lambda sensor in the vehicle.

VW UP. Elektrische Anlage Allgemeine Informationen

Protective sleeve variants of the universal lambda sensors


Note

In addition to identification by part number, the protective sleeve can also be used for identification.

Variant D1, 6 openings of 3.5 mm each

Only used with 4-pin LSF lambda sensors.

Variant D2, 6 openings of 2 mm each

VW UP. Elektrische Anlage Allgemeine Informationen

Used with 4-pin LSF and 6-pin LSU lambda sensors.

Variant D4, 12 openings of 1.4 mm each

VW UP. Elektrische Anlage Allgemeine Informationen

Used with 4-pin LSF and 6-pin LSU lambda sensors.

VW UP. Elektrische Anlage Allgemeine Informationen