Electrical System General Information
Wiring harness and connector repair
In this manual: Electrical System General Information
~2min read
General notes on electrical system repair
![]()
Caution!
When disconnecting and reconnecting the battery, follow the procedure described in the repair manual.
![]()
WARNING!
Some tools have a tool safety clip; after use, slide it over the tool tip to protect the technician from injury and the tool tip from damage.
- For all repairs, observe the current notes in the relevant repair manuals.
- Country-specific regulations must be observed.
- Before working on the electrical system, the battery negative cable must be disconnected. Disconnecting the battery negative cable (interrupting the current) ensures safe working on the electrical system. Disconnecting the battery positive cable is only required for removing the battery.
- Before starting any repair, be sure to first eliminate the cause of the damage (e.g. sharp-edged body parts, defective consumers, corrosion, etc.).
- For further information, such as installation and removal of individual components, refer to the relevant repair manual.
- Do not solder during repairs to the vehicle electrical system.

- Wiring harness and connector repairs on the vehicle electrical system may only be carried out using wiring harness repair kit -VAS 1978 B- and its predecessors. Only the yellow wires from wiring harness repair kit -VAS 1978 B- are to be used.
- Wiring harness repairs must not be re-wrapped into the factory wiring harness wrap and must be marked with yellow adhesive tape. This identifies a previous repair.

- Crimp connectors must not be repaired. If necessary, lay a wire parallel to the defective wire. After crimping, shrink the crimp connector with the hot-air blower to prevent moisture from entering.
- Also be sure to observe the supplementary notes on repairing wiring harnesses on airbag and belt tensioner systems, fiber optic cables, CAN bus wires, antenna cables and wire cross-sections down to 0.35 mm 2.
- Perform a function test after every repair. If necessary, read out and erase the fault memory and/or return the systems to their basic setting.

- Do not disconnect ground straps from the body if possible (risk of corrosion).

- The wiring harness repair set -VAS 1978 B- and its predecessors do not contain all wire cross-sections used in the vehicle. If the required wire cross-section is not available, use the next larger cross-section.
- Shielded wires may be repaired. Exception: wires for the camera systems. If damaged, they must be replaced completely.
- Heat-resistant wires are installed at various points in the vehicle, mainly in the engine compartment. Heat-resistant wires can be identified by their slightly duller and softer insulation. Only heat-resistant wires may be used to repair these wires.

Was this page helpful?