Electrical System General Information

Vehicle diagnosis, measurement and information systems

~2min read


WARNING!

  • During test or measurement drives with a vehicle diagnostic information system, there is a risk of serious or fatal injury!
  • If the vehicle diagnostic information system is placed within the deployment range of an airbag during a test or measurement drive, there is a risk of serious or fatal injury in the event of airbag deployment!
  • For test or measurement drives, take a person with you who operates the vehicle diagnostic information system from a rear seat.


Note

  • All described work procedures, such as adaptations, coding, etc., can be carried out with the vehicle diagnostic tester.
  • All work procedures can be accessed in the operating modes "Guided Fault Finding" and "Guided Functions".
  • Additional information:
    • → No. 202
    • → No. 256
    • → No. 294

- Connect vehicle diagnostic tester.

Connect vehicle diagnostic tester


Note

Observe the current operating instructions for the vehicle diagnostic tester, which are displayed after selecting the "Administration" and "Operating manual" buttons.

Required special tools, testers and equipment, and auxiliary items

  • Vehicle diagnostic tester
VW UP. Elektrische Anlage Allgemeine Informationen

  • Diagnostic lead -VAS 5051/6A- (5 m)
  • Diagnostic lead -VAS 5051/5A- (3 m)


Note

For diagnosis, only the diagnostic leads listed above may be used, as only these are equipped with CAN lines and permit CAN diagnosis or CAN communication.

Connect vehicle diagnostic tester:

- Apply the parking brake.

- On vehicles with automatic transmission, move the selector lever to position "P" or "N".

- On vehicles with manual transmission, move the gear lever to neutral.

VW UP. Elektrische Anlage Allgemeine Informationen

- With the ignition switched off, connect the vehicle diagnostic tester to the diagnostic connector -arrow- of the vehicle using diagnostic lead -VAS 5051/6A-.

- Switch the ignition on.

- Switch off all electrical consumers.


Note

All other and subsequent vehicle diagnostic, measurement and information systems or vehicle diagnostic and service information systems are connected in the same sequence as described above.

VW UP. Elektrische Anlage Allgemeine Informationen

Connect vehicle diagnostic tester Golf model year 1998 - 2003

- Apply the parking brake.

- On vehicles with automatic transmission, move the selector lever to position "P" or "N".

- On vehicles with manual transmission, move the gear lever to neutral.

- Pull the cover -1- out in the direction of the arrow.

- With the ignition switched off, connect the vehicle diagnostic tester to the diagnostic connector -arrow- of the vehicle using the diagnostic lead.

- Switch the ignition on.

- Switch off all electrical consumers.


Note

All other and subsequent vehicle diagnostic, measurement and information systems or vehicle diagnostic and service information systems are connected in the same sequence as described above.

VW UP. Elektrische Anlage Allgemeine Informationen