Chassis, Axles, Steering

Wheel bearing housing, wheel bearing unit, trailing arm

9steps
~54min
2/5difficulty
010203040503022N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Assembly Overview - Wheel Bearing Housing, Wheel Bearing Unit

VW UP. Fahrwerk, Achsen, Lenkung

  1. Axle beam
    • Remove and install
  2. Brake backing plate with brake shoes
  3. Bolt
    • Turn 30 N·m and then a further 90º
    • replace after every removal
  4. Stub axle
    • Straightening work is not permitted.
    • Re-cutting threads is not permitted!
  5. Wheel hub with wheel bearing
    • the ABS sensor ring is installed in the wheel hub
    • Remove and install

The wheel bearing and wheel hub are integrated together in one housing.

The wheel hub with wheel bearing is maintenance-free and requires no play adjustment. Adjustment and repair work is not possible!

  1. Twelve-point nut
    • Self-locking
    • Turn a further 30º after 70 N·m
    • replace after every removal
  2. Dust cap
    • replace after every removal
    • press out and drive in

A proper seal is only achieved with a new dust cap.

Only then is optimum function and long service life of the wheel bearing ensured.

  1. Brake drum
  2. Bolt
    • 8 N·m

Removing and installing wheel bearing unit

VW UP. Fahrwerk, Achsen, Lenkung

Required special tools, testers and equipment, and auxiliary items

  • Hub cap puller -VW 637/2-
  • Driver sleeve -3456-
  • Torque wrench -V.A.G 1332-
  • Torque wrench -V.A.G 1410-

Carry out the following work:

Removing

- Loosen the wheel bolts.

- Raise the vehicle.

- Remove wheel.

- Reset the brake.

- To do so, push the wedge upward with a screwdriver through a hole in the brake drum.

- Unscrew bolt -1- and remove brake drum -2-.

VW UP. Fahrwerk, Achsen, Lenkung

- Lightly tap the claw of the hub cap puller -VW 637/2--1- to release the dust cap from its seat.

VW UP. Fahrwerk, Achsen, Lenkung

- Press off the dust cap.

  1. Hub cap puller -VW 637/2-
VW UP. Fahrwerk, Achsen, Lenkung

- Unscrew 12-point nut -1-.

- Pull the wheel hub/wheel bearing unit -2- off the stub axle.

Installing

Installation is carried out in the reverse order. Observe the following:

VW UP. Fahrwerk, Achsen, Lenkung

- Carefully slide the wheel hub/wheel bearing unit -2- onto the stub axle.


Caution!

Make sure the wheel hub/wheel bearing unit does not tilt or jam!

- Screw on a new 12-point nut -1- and tighten to the specified tightening torque.

VW UP. Fahrwerk, Achsen, Lenkung

- Drive in a new dust cap using driver sleeve -3456--1-.

Always replace dust caps.

Damaged dust caps allow moisture to enter. Always use the tool shown.

- Install wheel and tighten.

VW UP. Fahrwerk, Achsen, Lenkung

Tightening torques