Power steering pump - Installation

1. After installing the bracket and pump, install the drive belt onto the pump pulley and adjust its tension. Tighten the tension adjusting bolt to the specified torque.

Tightening torque: 35 - 50 N·m 2. Connect the inlet hose.

The discharge hose must be connected to the power steering pump.

3. Tighten the discharge hose fitting on the power steering pump.

When installing the discharge hose, make sure it is not twisted and that there is no possibility of contact with other vehicle components.

4. Fill the power steering system with the recommended fluid: PSF-3. 5. Bleed air from the power steering system.

6. Check the power steering pump pressure.