Hyundai Elantra CN7 Quiz

Power Steering Pump - Installation

In this manual: Power Steering Pump - Installation
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
0204060801005037N·mlb·ft
Tightening torque found on this page
1. После установки кронштейна и насоса наденьте на шкив насоса ремень привода

1. After installing the bracket and pump, install the drive belt onto the pump pulley and adjust the belt tension. Tighten the tension adjusting bolt to the specified torque.

Tightening torque: 35 - 50 N·m 2. Connect the inlet hose.

The discharge hose must be connected to the power steering pump.

3. Tighten the discharge hose fitting on the power steering pump.

When installing the discharge hose, make sure it is not twisted and that it cannot contact other vehicle components.

4. Fill the power steering system with fluid. Recommended fluid: PSF-3. 5. Bleed air from the power steering system.

6. Check the power steering pump pressure.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.