Body

Hinges, Removing and Installing

~3min read
010203040502115N·mlb·ft
Tightening torque found on this page

Hinges, Removing and Installing, Sedan

Note

  • Remove and install the left and right hinges one after the other when replacing the hinges on both sides.
  • Mark the position of the hinges on the rear lid before removing them.
  • Use the markings on the rear lid hinge when adjusting the hinge lengthwise.
Hinges, Removing and Installing, Sedan

1 - Lid Hinge

Note

Have a second technician hold the rear lid so that it cannot fall down.

  • The luggage compartment side trim panel is removed. Refer to → Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels; Luggage Compartment Side Trim Panel, Removing and Installing.

- Remove the rear lid lower trim panel. Refer to → Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels; Lower Rear Lid Trim Panel, Removing and Installing.

- Remove the nuts -3- from the rear lid first.

- Remove the bolts -2- from the side panel and remove the hinge.

- Align the with the markings when installing and then tighten the bolts and nuts to the tightening specification.

- Check the gap dimensions.

2 - Bolt

  • 21 N·m

3 - Nut

  • 21 N·m

4 - Bracket

Hinges, Removing and Installing, Avant

Note

  • The rear lid drive units must be removed first on vehicles equipped with power lid actuation. Refer to → Chapter "Rear Lid Motor 1 and 2 -V444-/-V445-, Removing and Installing, Avant".
  • When installing, pay close attention to the tightening sequence for the bolts.
Hinges, Removing and Installing, Avant

1 - Lid Hinge

  • Removing:
    • Lower the headliner. Refer to → Body Interior; Rep. Gr.70; Roof Trim Panels; Headliner, Removing and Installing.
    • Remove the rear lid hinge cover → Fig.

Note

Support the rear lid to keep it from falling down and too prevent damage the rear lid or the vehicle body.

  • Remove the bolts -3- from the lid.
  • Remove the bolt -1- and hex nut -4- and then remove the hinge.
  • Installing:
    • Place the hinge onto the body and gently tighten the nut -4- on the roof frame.
    • Then lightly attach the hinge on the side with the bolt -3-.
    • Tighten the bolts -2- on the hinge.
    • Align the lid to the body on the left and right side and tighten the bolts -2- to the tightening specification.
    • Adjust the height of the lid to the roof and then tighten the bolt -3- and nut -4- to the tightening specification.
    • Press on hinge cover.

2 - Bolt

  • 30 N·m

3 - Bolt

  • 21 N·m

4 - Hex Nut

  • 21 N·m

Rear Lid Hinge Cover, Removing and Installing

Removing

- Cover is placed on rear lid hinge.

- Loosen side locking tabs on cover -1- and remove from hinge -2-.

Installing

Install in reverse order of removal. Note the following:

- To install, position retainer tabs in catches on hinge arm and press opposite side of cover down completely.

- The cover must audibly engage.

A55-10783