Body

Hood Latch, Removing and Installing

~3min read
010203040502115N·mlb·ft
Tightening torque found on this page

Rear Lid Lock, Removing and Installing, Sedan

Rear Lid Lock, Removing and Installing, Sedan

1 - Cover

  • Before removing the lid trim, remove from the lid latch

2 - Lid Latch

  • Before removal, remove the lid latch cover.
  • The rear lid lower trim panel is removed. Refer to → Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels; Lower Rear Lid Trim Panel, Removing and Installing.
  • Disconnect the connector.
  • Remove nuts and remove lid latch.
  • Remove the lid latch with the clip from the centering hole.

3 - Nut

  • 21 N·m

4 - Cover for Lid Latch

  • When installing, cover must engage audibly in lid latch.

5 - Release Cable

  • Market-specific

Hood Latch, Removing and Installing, Avant

Hood Latch, Removing and Installing, Avant

1 - Cover for Lid Latch

  • When assembling, cover must engage audibly into lid latch.
  • Mount the cover onto the lid latch.

2 - Nuts

  • 21 N·m

3 - Cover

  • Mount the cover on the lock until it audibly clicks into place.

4 - Lid Latch

  • Remove the cover for the lid latch.
  • Remove the rear lid trim panel. Refer to → Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels; Lower Rear Lid Trim Panel, Removing and Installing
  • Remove the cover -3-.
  • Disconnect the connector to the lid latch.
  • Remove the nuts -2- and then remove the lid latch.

5 - Connector

6 - Rear Lid

Lid Latch Emergency Release, Removing and Installing, Sedan

Note

The emergency release is installed only in vehicles with a fixed rear panel.

Routing on the Lid Side

Routing on the Lid Side

1 - Release Cable

Note

  • When re-installing, route the release cable starting from the lid latch on the inside of the lid, over the hinge and into the vehicle interior.
  • The clips for the cable have been prepositioned and can be inserted into the holes.
  • Before removing, unclip the cover on the lid latch
  • First unclip from the cable bracket on the lid latch and then disengage from the release lever.

2 - Rear Lid Trim Panel

  • Removed. Refer to → Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels; Lower Rear Lid Trim Panel, Removing and Installing.

3 - Lid Latch

4 - Cover

  • Unclip from the rear lid latch

5 - Emergency Release Lever

  • When installing, first engage the release cable on the release lever and then press it into the cable bracket on the lid latch.

6 - Clip

  • Pre-positioned on the release cable

Routing on the Body Side

Routing on the Body Side

1 - Eye

  • Secure it under the rear seat bench with tape

2 - Bracket

  • No replacement part
  • Engage the release cable in the bracket on the rear lid latch as illustrated.

3 - Rear Lid Latch

4 - Release Cable

  • Starting from the lid latch, route the cable over the lid hinge and into the vehicle interior as illustrated.
  • Mounted on the lid hinge and attach it to the back side with the cover.
  • The cable must be correctly routed into the cover.

5 - Clip

  • The clips have been prepositioned and must be clipped into the holes.