Body

Hood, Removing and Installing

~1min read

Hood Impact Guard, Replacing

Note

The impact guard is also equipped with double-sided adhesive tape.

Hood Impact Guard, Replacing

1 - Clip

2 - Impact Guard

  • To remove, remove the clip from the hood and then remove the impact guard.

3 - Door

Hood Seal, Removing and Installing

Hood Seal, Removing and Installing

1 - Gasket for Plenum Chamber

  • To remove, pull forward off the body flange.
  • Mount the seal on the foam piece and then push it onto the flange on the body.
  • Mount the seal on the opposite side on the foam piece and push it onto the flange on the body.
  • Press the seal on the opposite side on the flange on the body using up any overlap.

2 - Right Sealing Profile

  • To remove, unclip it from the fender flange and the suspension strut tower.
  • Press the clips on the foam piece into the body when installing.

3 - Plenum Chamber Bulkhead

  • Slide the plenum chamber seal on at the sides.