Propeller shaft seal in transmission case

GENERAL INFORMATION

Propeller shaft seal in transmission case A. TRANSMISSION CASE.

5. BALL BEARING.

10. CV JOINT RETAINER.

13. SHAFT SEAL

Remove or disconnect

Removal of seal A. TRANSMISSION CASE

Removing propeller shaft from transmission case A. SCREWDRIVER.

B. HAMMER.

7. CLAMP.

8. BOOT

10. SHAFT

See description of operations 1, 2 and 4 through 8 in subsection 15.3.

PROCEDURE.

1. Place an oil drain pan under the transmission case..

2. Using the tool, remove the propeller shaft from the transmission case. After

removing the shaft from the case, secure the shaft..

3. Remove seal..

4. Inspect the seal seat bore and the working surface contacting the seal lip..

Install or connect

Installation of seal A. HAMMER WITH PLASTIC TIP

PROCEDURE.

1. Propeller shaft seal.

1a. Lubricate the seal lip with transmission oil..

2. Propeller shaft. Check that the snap ring is securely seated in the groove..

3. Lower control arm and tie rod ball joints. Tighten the tie rod ball joint nut

to torque 60 N·m. Install cotter pin if specified. Tighten the lower control arm ball joint nut to torque 70 N·m..

Install spring retainer..

4. Install the wheel..

5. Lower the vehicle to the floor..

6. Tighten the wheel bolts to 90 N·m..

7. Tighten the nuts securing the strut upper mount to the body.

to 30 N·m..

8. Install the wheel cover..

9. Check the transmission fluid level and top up to the specified level.