AutoPark

AutoPark is an optional feature that helps place the vehicle in PARK when certain conditions occur, as described on the following pages. It is a backup system and should not be relied upon as the primary method by which the driver shifts the vehicle into PARK.

The conditions under which AutoPark will activate are described below. See the following pages.

• Driver inattention may result in failure to place the vehicle in PARK. ALWAYS CHECK VISUALLY that your vehicle is in PARK by confirming that the "P" indicator is not flashing on the instrument cluster display and on the gear selector. If the "P" indicator is flashing, your vehicle is not in PARK. As an additional precaution, always apply the parking brake when exiting the vehicle.
• AutoPark is an optional feature. It is not intended to replace the need to shift the vehicle into PARK. It is a backup system and should not be relied upon as the primary method by which the driver shifts the vehicle into PARK.

If the vehicle is not in PARK and the driver turns the engine off, the vehicle may AutoPark.

AutoPark will activate when all of the following conditions are met:

• The vehicle is equipped with an eight-speed automatic transmission
• The vehicle is not in PARK
• Vehicle speed is 1.2 mph (1.9 km/h) or less
• The ignition switch is changed from ON/RUN to ACC

NOTE:

On vehicles equipped with Keyless Enter-N-Go, the engine will turn off and the ignition switch will change to the ACC mode.

If the vehicle is not in PARK and the driver exits the vehicle while the engine is running, the vehicle may AutoPark.

AutoPark will activate when all of the following conditions are met:

• The vehicle is equipped with an eight-speed automatic transmission
• The vehicle is not in PARK
• Vehicle speed is 1.2 mph (1.9 km/h) or less
• The driver's seat belt is not fastened
• The driver's door is open
• The brake pedal is not depressed

The message " AutoPark Active Shift to P, then shift to Gear " will be displayed in the instrument cluster.

NOTE:

In some cases, the ParkSense graphic will be displayed in the instrument cluster. In these cases, the gear selector must be returned to the "P" position in order to select the desired gear.

If the driver shifts into PARK while the vehicle is moving, the vehicle may AutoPark.

AutoPark will engage ONLY when the vehicle speed is 1.2 mph (1.9 km/h) or less.

The message " Vehicle Speed Too High to Shift to P " will be displayed in the instrument cluster if vehicle speed exceeds 1.2 mph (1.9 km/h).

ALWAYS PERFORM A VISUAL CHECK that your vehicle is in PARK by looking for the "P" on the instrument cluster display and on the gear selector. As an additional precaution, always apply the parking brake when exiting the vehicle.