Driver Knee Airbag. Removal and Installation

Removal

1. 1
   If an SRS fault is present, GO to step 2. Otherwise, turn the ignition off, wait at least one minute and GO to step 3.
2. 2
   Disable the SRS.
   Refer to: Disabling and Enabling the Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, General Procedures).
3. 3
   Remove the screws, release the outer clips on each side and remove the lower steering column shroud.

   

4. 4
   Disconnect the lower instrument panel trim panel.

   

5. 5
   Disconnect the tabs and disconnect the in-vehicle temperature and humidity sensor.

   

6. 6
   Remove the nuts and lower the driver knee air bag.
   Torque: 97 lb-in (11 N·m)

   

7. 7
   Disconnect the electrical connector and remove the driver knee air bag.

   

Installation

1. 1
   To install, reverse the removal procedure.
2. 2
   If the SRS was disabled, enable the SRS.
   Refer to: Disabling and Enabling the Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, General Procedures).