Engine Mount. Removal and Installation

Special Service Tools / General Equipment

Removal

1. 1
   Position the vehicle in NEUTRAL on the lift.
   Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
2. 2
   Release the tab, remove the retainer, and set the degas bottle aside.

   

3. 3
   Remove the retainers and the lower engine splash shield.

   

4. 4
   Install the following components:

   • Use common shop equipment: Jack Stand
     Use common shop equipment: Wood block

   

5. 5
   Remove the engine appearance cover.

   

6. 6
   • Remove the bolts, nuts and engine mount.

   • Discard the nuts and bolts.

   

Installation

1. 1
   Tighten the engine mount studs.
   Torque: 89 lb-in (10 N·m)

   

2. 2
   1. Install the engine mount and new nuts.
      Torque: 85 lb-ft (115 N·m)

   2. Install the new engine mount bolts, hand-tightening them.

   

3. 3
   Remove the following components:

   • Use common shop equipment: Jack Stand
     Use common shop equipment: Wood block

   

4. 4
   Tighten the engine mount bolts.
   Torque: 66 lb-ft (90 N·m)

   

5. 5
   Install the engine outer cover.

   

6. 6
   Install the engine shield and clips.

   

7. 7
   Position the degas bottle and install the retainer.
   Torque: 80 lb-in (9 N·m)