Brake Line Repair Procedures

Removal

1. 1
   Disconnect the negative (-) battery cable.
2. 2
   Disconnect the brake fluid level switch connector.

   

3. 3
   Remove the brake fluid from the master cylinder reservoir using a syringe.

   Do not spill brake fluid on the vehicle, as it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

4. 4
   Remove the wheel and tire.
5. 5
   Remove the brake hose clamp (A).
6. 6
   Disconnect the brake tube by loosening the tube flare nut (B).

   Tightening torque: 12.7 - 16.7 N·m

   [Front]

   

   [Rear]

   

7. 7
   Disconnect the brake hose by loosening the bolts (A) and (B).

   Tightening torque: 24.5 - 29 N·m

   [Front]

   

   [Rear Disc]

   

   [Rear Drum]

   

8. 8
   Remove the brake hose bracket by loosening the bolt (A). [Drum Brake Only]

   Tightening torque: 18.6 ~ 26 N·m

   

Inspection

1. 1
   Inspect the brake tubes for cracks, bends and corrosion.
2. 2
   Inspect the brake hoses for cracks, damage and fluid leaks.
3. 3
   Inspect the tube flare nuts for damage and fluid leaks.
4. 4
   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1
   To install, reverse the removal procedure.

   Use a new gasket (A) when installing.

2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake Bleeding") (Refer to Brake System - "ABS Bleeding") (Refer to Brake System - "ESP Bleeding")
3. 3
   Inspect for spilled brake fluid.