Front Door Latch Repair Procedures

Replacement

1. 1
   Remove the front door module. (Refer to Front Door - "Front Door Module")
2. 2
   Remove the front door inside handle (A).

   

3. 3
   Disconnect the front door lock connector (A).

   

4. 4
   Remove the front door latch assembly (A) by pulling it in the direction indicated by the arrow.

   

5. 5
   To disconnect the front door outside handle base connector (A), spread both sides of the wiring retainer, then pull the front part of the outside handle base connector.

   

6. 6
   Disconnect the front door outside handle connector (A).

   

7. 7
   Remove the front door outside handle base (A) by pressing the stopper pins at the rear.

   

8. 8
   Remove the front door outside handle cable (A).

   

9. 9
   To install, reverse the removal procedure.

   Make sure the connector is properly connected. Check that the door locks/unlocks and opens/closes properly. Replace any damaged clips (or pin-type retainers).