Repair Procedures

Adjustment

Inspect the window guide channel for damage or wear, and replace it if necessary.

1. 1
   Remove the front door trim. (Refer to Front Door - "Front Door Trim")
2. 2
   Separate the installation plug hole (A) from the front door module.

   

3. 3
   After loosening the window mounting bolts, adjust the window gap (A) by moving the window side to side, then tighten the bolts.

   

4. 4
   Check that the window operates normally.

Make sure the door latches securely without slamming it. If necessary to adjust the striker (A): The striker nuts are secured. The striker can be precisely adjusted up or down, in or out.

1. 1
   After loosening the mounting screw, adjust the latch (A) by moving it forward and backward or side to side, then tighten the bolts (B).

   Tightening torque: (B): 18.6 ~ 28 N·m

   

2. 2
   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.
3. 3
   While holding the outside handle, press the door against the body to make sure the striker allows flush seating. If the door latches correctly, tighten the screws and recheck.

After installing the door, make sure the body is flush with and parallel to all edges of the front door. Make sure the door and body edges are parallel. Replace the mounting bolts before adjusting.

1. 1
   Make sure the door and body edges are parallel.

   

2. 2
   Before adjusting the doors, park the vehicle on a level surface.
3. 3
   Adjust the hinges (A):

   A.	Slightly loosen the door mounting bolts and move the door in or out until it is flush with the body.

   B.	Slightly loosen the hinge mounting bolts and move the door forward or backward, up or down as necessary.

   C.	Place a shop towel on the jack to avoid damaging the door during adjustment.

   Tightening torque: (B): 21.6 ~ 26 N·m (C): 37.3 ~ 41 N·m

   

4. 4
   Lubricate the moving parts of the specified hinges.
5. 5
   Check for water leaks.