Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Front Door Module Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
12steps
~72min
3/5difficulty
010203040502.92N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Replacement

  1. Remove the front door window glass. (Refer to Front Door - "Front Door Window Glass")
  2. Remove the front door outside handle. (Refer to Front Door - "Front Door Outside Module")
  3. Loosen the front door outside handle base mounting bolt (A).

    Tightening torque: 2.0 ~ 2.9 N·m

  4. Disconnect the front door main connector (A) and the outside rearview mirror connector (B).
  5. Loosen the front door latch mounting screws.

    Tightening torque: 7.8 ~ 14.7 N·m

  6. Loosen the mounting bolts and remove the front door module (A).

    Tightening torque: 8.8 ~ 13.7 N·m

  7. Disconnect the connectors and wire harness of the front door module (A).
  8. Remove the front door lock assembly. (Refer to Front Door - "Front Door Latch")
  9. Remove the front speaker. (Refer to Body Electrical System - "Speakers")
  10. Remove the front power window motor. (Refer to Body Electrical System - "Power Window Motor")
  11. Remove the side impact sensor. (Refer to Passive Safety System - "Side Impact Sensor (SIS)").
  12. To install, reverse the removal procedure.
    • Check that the connectors are connected correctly and that each rod is securely connected.
    • Check that the door locks/unlocks and opens/closes properly.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.