Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Front Door Trim Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
5steps
~30min
2/5difficulty
Done 0 of 5

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Be careful not to scratch the door trim and other parts.
  1. Using a screwdriver or removal tool, remove the front door handle bezel inner cover (A).
  2. Loosen the screws and remove the lower front door trim panel (A) using a flat-tip screwdriver.
  3. Remove the front door inside handle (A).
  4. Disconnect the front door lamp connector (A) and the power window switch connector (B).
  5. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Check that the door locks/unlocks and opens/closes properly.
    • Replace any damaged clips (or pin-type retainers).
    • Check that the window operates properly.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.