Ball Joint Rotating Torque Inspection - Steering Tie Rod End

1. Using the special service tool, disconnect the steering tie rod end ball joint from the steering knuckle.

2. Move the ball joint stud several times to check that there is no excessive free play.

3. Install the nut on the ball joint stud, then measure the ball joint rotating torque.

Standard value:

0.5 - 2.5 N·m 4. If the measured value is greater than the upper limit of the standard value, replace the steering tie rod end.

5. If the measured value is less than the lower limit of the standard value, check the ball joint for excessive play or binding, and replace if necessary.