Hyundai Elantra CN7 Quiz

Steering Column and Steering Shaft - Inspection, Installation, Disassembly and Assembly

In this manual: Steering Column and Steering Shaft - Inspection, Installation, Disassembly and Assembly
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read

INSPECTION

1. Inspect the steering shaft for deformation and damage.

2. Check the joints for excessive play, damage and binding (smooth movement).

3. Check the steering universal joint bearings for wear and damage.

INSTALLATION

Installation is performed in the reverse order of removal.

STEERING COLUMN LOCK ASSEMBLY - DISASSEMBLY AND ASSEMBLY

1. Если необходимо снятие замка рулевой колонки в сборе, то с помощью зубила

1. If it is necessary to remove the steering column lock assembly, use a chisel to cut a groove in the head of the lock mounting bolt (shear-off head), then use a screwdriver to remove the steering column lock bracket.

2. Снимите замок рулевой колонки с рулевой колонки и вала рулевого управления

2. Remove the steering column lock from the steering column and steering shaft assembly.

3. Installation is performed in the reverse order of removal.

STEERING UNIVERSAL JOINT

1. Отверните болт крепления соединения карданного вала рулевого управления с

1. Remove the bolt securing the steering universal joint to the steering shaft.

2. Отсоедините карданный вал рулевого управления в сборе от рулевой колонки и

2. Disconnect the steering universal joint assembly from the steering column and steering shaft assembly.

3. Installation is performed in the reverse order of removal.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.