Rear Door Glass Repair Procedures

Replacement

1. 1
   Lower the rear door glass by pressing the power window switch.
2. 2
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
3. 3
   Loosen the mounting screws and remove the rear door belt outside weatherstrip (A).

   

4. 4
   After loosening the mounting screws, remove the rear door delta garnish (A).

   

   

5. 5
   Fully loosen the rear door channel mounting bolt and loosen the nuts as far as possible without removing them from the rear door panel. Tightening torque: Bolt: 6.9 ~ 10.8 N·m Nut: 3.9 ~ 5.9 N·m
6. 6
   Lightly press the rear door channel in the direction of the arrow, as shown below.

   

7. 7
   Remove the rear door glass mounting hole cap (A). Loosen the rear triangle lower channel mounting bolts (C).

   

8. 8
   Carefully adjust the rear door glass (A) so that the bolt is visible, then loosen them. Separate the glass from the glass bracket and carefully pull the glass out through the window opening.

   Tightening torque: 7.8 ~ 11.8 N·m

   

   Be careful not to drop the glass and/or scratch its surface.

   Using the door switch, align the mounting hole/bolt with the hole in the door. If the window regulator motor does not operate, remove the motor and align the hole manually.

9. 9
   Install in the reverse order of removal.

   Make sure the glass raises and lowers smoothly. If necessary, adjust the glass position. Make sure the door locks and unlocks properly. Replace all damaged clips.