Hyundai i20 Quiz
Engine Mechanical System

Crankshaft Damper Pulley Repair Procedures

In this manual: Engine Mechanical System
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
5steps
~40min
3/5difficulty
2special tools
02040608010061.846N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal and Installation

  1. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  2. Remove the drive belt. (Refer to Valve Timing System - "Drive Belt")
  3. Remove the right front wheel. (Refer to Suspension System - "Wheel")
  4. Remove the crankshaft damper pulley.
    1. Using SST (09231-2M100, 09231-2J210), hold the crankshaft damper pulley (A).
    2. Remove the crankshaft damper pulley mounting bolt, then remove the crankshaft damper pulley (A).

    Tightening torque: [5.9 – 62 N·m] + 47–50°

  5. To install, perform the removal procedure in reverse order.

Inspection

Check the crankshaft damper pulley for vibration when rotating and for dust or oil on the V-ribbed section. Replace if necessary.

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.