Hyundai Palisade Quiz
Brake System

Brake Pedal

In this manual: Brake System
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
8steps
~48min
2/5difficulty
0102030405025.519N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Component Location

Components

Hyundai Palisade. Components and components location
1. Brake Pedal Assembly
2. Stop Lamp Switch		 3. Brake Pedal Lever Assembly
4. Brake Pedal Pad

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the emergency pad lower panel. (Refer to Body - "Emergency Pad Lower Panel")
  3. Disconnect the stop lamp switch connector (A).
    Hyundai Palisade. Repair procedures
  4. Separate the lock pin (A) and the flat head pin (B).
    Hyundai Palisade. Repair procedures
  5. Remove the brake pedal assembly after loosening the mounting nuts (A).

    Tightening torque: 16.7–26 N·m

    Hyundai Palisade. Repair procedures
    Hyundai Palisade. Repair procedures

Inspection

  1. Inspect the brake pedal for bending or twisting.
  2. Inspect the brake pedal return spring for damage.
  3. Inspect the stop lamp switch. (Refer to Brake System - "Stop Lamp Switch").

Installation

  1. To install, reverse the removal procedure.
    Hyundai Palisade. Repair procedures
    • When installing the pin, apply grease.
    • When installing, use a new clip.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.