Master Cylinder

Components and Component Location

Components

Repair Procedures

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
3. 3
   Disconnect the brake fluid level sensor connector (A).

   

4. 4
   Remove the brake fluid from the master cylinder reservoir using a syringe.

   Do not spill brake fluid on the vehicle, as it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water. Make sure that dirt or other foreign matter does not contaminate the brake fluid.

5. 5
   Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

   Tightening torque: 18.6 – 23 N·m

   

6. 6
   Remove the master cylinder (A) after loosening the master cylinder nuts.

   Tightening torque: 12.7–15.7 N·m

   

7. 7
   Separate the reservoir from the master cylinder after removing the screw (A).

   

Installation

1. 1
   To install, reverse the removal procedure.

   Apply grease to the joint before installing the pin. When installing, use a new clip.

2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake System Bleeding") (Refer to Brake System - "ESP System Bleeding")
3. 3
   Check for brake fluid leakage and pedal condition.