Oil pressure sensor

Repair Procedures

Removal and Installation

Be careful not to damage parts located under the vehicle (floor under cover, fuel filter, fuel tank, and canister) when lifting the vehicle with a lift. (Refer to General Information - Jack Lifting Points and Support Points)

1. 1
   Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover")
2. 2
   Remove the engine cover. (Refer to Engine and Transaxle Assembly - Engine Cover)
3. 3
   Drain the engine coolant. (Refer to Cooling System — Engine Coolant)
4. 4
   Remove the air cleaner assembly. (Refer to Air Intake and Exhaust System - "Air Cleaner").
5. 5
   Remove the expansion tank. (Refer to Intake and Exhaust System - "Expansion Tank")
6. 6
   Remove the intake manifold. (Refer to Intake and Exhaust Systems — Intake Manifold)
7. 7
   Remove the delivery pipe. (See Engine Control/Fuel System - Delivery Pipe)
8. 8
   Remove the water temperature control unit and the center water pipe. (Refer to Cooling System - "Water Temperature Control Assembly")
9. 9
   Disconnect the oil pressure sensor connector (A).

   

10. 10
    Remove the oil pressure switch (A).

    Tightening torque: 14.7–22 N·m

    

11. 11
    Install in the reverse order of removal.

    When installing, apply sealant to the threaded portion. Sealant lock: 3M 2510. Thickness: more than 0.4 mm (0.0157 in)