Rear Oil Seal

Repair Procedures

Replacement

Be careful not to damage parts located under the vehicle (floor under cover, fuel filter, fuel tank, and canister) when lifting the vehicle with a lift. (Refer to General Information - Jack Lifting Points and Support Points)

1. 1
   Remove the transaxle assembly. (Refer to Automatic Transaxle System - "Automatic Transaxle")
2. 2
   Remove the drive plate. (Refer to Cylinder Block - "Drive Plate")
3. 3
   Remove the rear oil seal (A).

   

4. 4
   Remove the rear oil seal retainer (A).

   

Installation

1. 1
   Install the rear oil seal retainer (A).

   Tightening Torque: 9.8–11.8 N·m

   

   Clean the sealing surfaces before assembling the two parts. Remove all harmful foreign material from the sealing surface before applying sealant. Before assembling the rear oil seal retainer, apply liquid sealant TB1217H to the rear oil seal retainer. Assemble the parts within 5 minutes after applying the sealant. Apply sealant to the internal threads of the bolt holes.

2. 2
   Using SST (09231-3C200, 09231-H1100), install the rear oil seal.

   

   Do not reuse the rear oil seal.

3. 3
   Install the remaining parts in the reverse order of removal.