Rear Upper Arm

Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 107.9–128 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

   

3. 3
   Loosen the bolt and nut, then remove the rear upper arm (A) from the rear axle.

   Tightening torque: 98.0–118 N·m

   Place a transmission jack under the lower arm to remove it without applying load.

   

Inspection

1. 1
   Inspect the bushing for wear and damage.
2. 2
   Check the rear upper arm for damage and deformation.
3. 3
   Check that all bolts and nuts are present.

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   Check the alignment. (Refer to Suspension System - "Alignment")