Rear Coil Spring

Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 107.9–128 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

   

3. 3
   Loosen the bolt and nut and remove the rear lower arm (A) from the rear axle.

   Tightening torque: 137.3–157 N·m

   Place a transmission jack under the lower arm to remove it without applying load.

   

4. 4
   Loosen the bolt and nut (A), then disconnect the rear shock absorber from the lower arm.

   Tightening torque: 137.3–157 N·m

   

5. 5
   Loosen the nut (A) and disconnect the stabilizer link from the lower arm.

   Tightening torque: 98.0–118 N·m

   

6. 6
   Remove the coil spring (A).

   

Inspection

1. 1
   Check the spring for deformation, aging, or damage.
2. 2
   Check the upper and lower spring seats for wear or damage.

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   Check the alignment. (Refer to Suspension System - "Alignment")