Trailing Arm

Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 107.9–128 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

   

3. 3
   Disconnect the EPB connector (A).

   

4. 4
   Loosen the bolt (A) and remove the rear wheel speed sensor.

   Tightening torque: 6.9–10.8 N·m

   

5. 5
   Loosen the bolt and remove the rear wheel speed sensor cable (A).

   Tightening Torque: 9.8–16.7 N·m

   

6. 6
   Loosen the nut (A) and disconnect the trailing arm from the rear axle.

   Tightening torque: 98.0–118 N·m

   Place a transmission jack under the lower arm to remove it without applying load.

   

7. 7
   Loosen the bolt (A) and remove the trailing arm.

   Tightening torque: 98.1 - 118 N·m

   

Inspection

1. 1
   Inspect the bushing for wear and damage.
2. 2
   Check that all bolts and nuts are present.

Installation

1. 1
   Install in the reverse order of removal.
2. 2
   Check the alignment. (Refer to Suspension System - "Alignment")