Rear shock absorber

Components and Component Location

Components

Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 107.9–128 N·m

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

   

3. 3
   Remove the rear shock absorber (A) from the body by loosening the bolt.

   Tightening torque: 98.1 - 118 N·m

   

4. 4
   Loosen the bolt and nut, then remove the rear shock absorber (A) from the lower arm.

   Tightening torque: 137.3–157 N·m

   

Disassembly

1. 1
   Remove the lock nut cover (A).

   

2. 2
   Using the special service tool (09546-S1100), install the self-locking nut.

   

3. 3
   Separate the insulator assembly (A), rubber bumper (B), dust cover (C), and shock absorber (D).

   

Inspection

1. 1
   Inspect the rubber components for damage or wear.
2. 2
   Check the shock absorber for abnormal resistance or unusual noise.

   

Disposal

1. 1
   Fully extend the shock absorber piston rod.
2. 2
   Drill a hole to release the gas from the cylinder.

   

   The escaping gas is harmless, but be careful of chips that may fly off during drilling. Always wear a protective mask and safety glasses.

Installation

1. 1
   To reinstall, perform the removal procedure in reverse order.
2. 2
   Using the SST (09546-3X100), install the lock nut.

   Do not reuse the self-locking nut.

   Tightening torque: 29 N·m

   

3. 3
   Install the lock nut cover (A).

   

Installation

1. Install in the reverse order of removal.