Jeep Wrangler: Lowering the Soft Top to the Sunrider® Position / Lowering the Soft Top to the Sunrider® Position

Fold both sun visors forward, toward the windshield.
Release the header latches from the crossbar by pulling the handle down. Make sure the hook is disconnected from the receiver.

Step Two
On the left and right sides, lift bow #1 of the soft top to begin the operation.

Step Three
Step away from the vehicle and use the side straps to fold the soft top back into the Sunrider® position.

Step Four

NOTE:

If leaving the soft top in the Sunrider® position, secure the top with the two hooks and tie-down loops provided in the center console.

Step Four

NOTE:

The vehicle may be driven in the Sunrider® position with the rear window and quarter panel assemblies fully installed or fully removed.

The rear window and rear quarter windows must be removed before fully lowering the soft top to prevent damage to the top. Cleaning the side and rear windows before removal helps prevent scratches while removing the soft top. If the plastic fasteners are difficult to operate due to road dust or similar, clean them with a mild soapy solution and a small brush. Cleaning products are available from an authorized dealer.

Lowering the Soft Top to the Sunrider® Position