Kia Cadenza VG Owner's Manual Quiz
Automatic Transmission

35R Clutch Control Solenoid Valve (35R/C_VFS) Repair Procedures

In this manual: Automatic Transmission
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
4steps
~24min
2/5difficulty
Done 0 of 4

Inspection

  1. Turn the ignition off.
  2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  3. Disconnect the solenoid valve connector (A).
  4. Measure the resistance between the power terminal (10) and the signal terminal (6).

    Specification: 5.1 ± 0.3 Ω

Replacement
If replacement of a VFS-type solenoid valve is required, the valve body assembly must be replaced and the oil pressure must be adjusted. If the solenoid valve is replaced separately, the oil pressure cannot be adjusted without special equipment, and if the oil pressure adjustment procedure is not performed, shift shock or shift delay may occur.
  1. Replace the valve body assembly. (Refer to Hydraulic System - "Valve Body")

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.