Kia Cadenza VG Owner's Manual Quiz
Automatic Transmission

Input Speed Sensor Repair Procedures

In this manual: Automatic Transmission
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Turn the ignition off.
  2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  3. Disconnect the solenoid valve connector (A).
  4. Measure the resistance between power terminal (14) and signal terminal (8).

    Specification: approx. 0.88 MΩ

Removal

  1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")
  2. Disconnect the input and output speed sensor connector (A).
  3. Remove the input and output speed sensors (B) after loosening the bolts.

    Tightening torque: 9.8 ~ 11.8 N·m

Installation

  1. Install in the reverse order of removal.
    • Fill the automatic transmission with fluid. (Refer to Hydraulic System — "Fluid").
    • Check for fluid leaks at the connections after repair.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.