Shift Cable Repair Procedures

Removal

1. 1
   Remove the center console assembly. (Refer to Body - "Console")
2. 2
   Remove the air duct (A).

   

3. 3
   Remove the control cable (B).

   

4. 4
   Disconnect the shift cable (A), then remove the cable (B) after pressing the shift cable socket (C) in the direction "F".

   

   Shift Cable Installation Method at the Lever Securely install the cable connector part to the lever assembly after aligning the cable connector protrusions (A) upward. Securely install the cable connector part to the lever assembly after aligning the protrusion (B) to prevent incorrect assembly upward.

5. 5
   Remove the control cable assembly from the vehicle after removing the nuts (B) and the clip (A).

   Tightening torque: 8.8 - 13.7 N·m

   

6. 6
   Remove the nut (C).
7. 7
   Remove the control cable (B) by loosening the nut (C) and bolt (A). Tightening torque: (A) 14.7 ~ 22 N·m (C) 8.8 ~ 13.7 N·m

   

8. 8
   Remove the control cable inside the cabin.

Installation

1. Installation is the reverse of removal.

   Make sure the vehicle does not roll before setting the cabin side shift lever and the automatic transmission (AT) side shift lever to the "N" position.

Adjustment

T/M control cable adjustment procedure

1. 1
   Make sure the vehicle does not roll before setting the cabin side shift lever and the automatic transmission (AT) side shift lever to the "N" position.
2. 2
   Connect the cabin side shift lever and the control cable.
3. 3
   Push the cable in the direction shown by "F" to eliminate the FREE PLAY.
4. 4
   Tighten the adjusting nut (A).

   Tightening torque: 8.8 - 13.7 N·m

   

5. 5
   After adjustment, make sure this part operates as designed for each automatic transmission (AT) range corresponding to each cabin lever position.