Suspension System
Description and Operation
In this manual: Suspension System
6steps
~36min
2/5difficulty
Done 0 of 6
Description
Tread Lamp- Tire Inflation / Leak Warning
- Turn-on condition
- When tire pressure is below the threshold
- When the sensor detects a rapid leak.
- Turn-off condition
- Under-inflation; when tire pressure is above (warning threshold + hysteresis).
- Rapid leak; when tire pressure is above (leak warning threshold).
- Turn-on condition
- At the same time as the TREAD Lamp.
- Indicates the wheel location where insufficient inflation / leakage has occurred.
- Turn-off condition
- At the same time as the TREAD Lamp.
If the wheel locations change between ignition cycles, the system retains the previous Auto-Location position. Once Auto-Location is completed in the current ignition cycle, the correct lamp will illuminate.
- Turn-on condition
- When the system detects a malfunction that is external to the receiver/sensor.
- When the system detects a receiver malfunction.
- When the system detects a sensor malfunction.
- Turn-off condition
- If a malfunction is considered "critical," the lamp remains illuminated for the entire current ignition cycle (even if the DTC has been downgraded). This is because it is important to bring the problem to the driver's attention. In the next ignition cycle, the downgrade conditions will be re-checked. When the downgrade conditions occur, the lamp will turn off. It will remain on until the DTC downgrade check is performed.
- "Non-critical" malfunctions are those that may occur temporarily, for example, due to low vehicle battery voltage. Therefore, the lamp turns off when the DTC downgrade condition occurs.
|
Test yourself
A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?