Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Rear Combination Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
Done 0 of 11

Rear Combination Lamp (Outside)

  1. Disconnect the negative (-) battery terminal.
  2. If only the bulbs are to be replaced without removing the lamp assembly, replace the turn signal lamp bulb (B) after removing the trim cover (A) in the luggage compartment.
  3. Remove the nuts (4 pcs.).
  4. Remove the rear combination lamp (A) by disconnecting the connector (B).
  5. Turn the socket counterclockwise to remove the turn signal lamp (A).
  6. Disconnect the negative (-) battery terminal.
  7. If only the bulbs are to be replaced without removing the lamp assembly, replace the back-up lamp bulb (A) after removing the trim cover in the luggage compartment.
  8. Remove the rear combination lamp (A) by disconnecting the connector and removing the nuts (3EA).
  9. Turn the socket counterclockwise to remove the back-up lamp (A).
Rear Combination Lamp (Inside)

Installation

  1. Install the rear combination lamp assembly after installing the bulb.
  2. Install the lamp cover on the tailgate after connecting the lamp connector.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.